Sap2000: Dividir viga

[Layzer]

Hola  a todos.

Podrian ayudarme, lo que quiero es obtener los resultados de los momentos en la viga, pero a un espacio menor, creo k el sap divide la viga en 6 partes, como hago para tener mayores divisiones?.

Gracias.

[ralarcon]

Hola  a todos.

Podrian ayudarme, lo que quiero es obtener los resultados de los momentos en la viga, pero a un espacio menor, creo k el sap divide la viga en 6 partes, como hago para tener mayores divisiones?.

Gracias.

Select All > Assign > Frame/Line > Frame Output Stations


Frame Output Stations

   
• Frame Output Station  Form:  Assign Output Station   Spacing
  Frame output stations are designated locations along a frame   element. They are used as locations to report output forces, perform design, and   plot points used for graphic display of force diagrams. When force diagrams are   plotted, exact forces are plotted at each output station and then these points   are connected by straight lines.
  Important   note: Output stations occur at user-specified locations and at point load locations along a beam.
  Assign output stations to frame   elements as follows:
  
  
        
  •   Select the line object to which the assignment is to be   made.
  •   Select the  Assign menu > Frame/Line >   Frame Output Stations command
  •   Choose one of the following options:
  
        
  •   Max Station Spacing     
       ETABS provides an output station at each point load   location. Then ETABS provides an equally spaced number of stations between each   adjacent pair of point loads where the spacing does not exceed the specified   maximum spacing.
    By default, for beams, output stations are provided at a   maximum spacing of 2 feet for English units and 0.5 meter for metric units, and   of course, at all point load locations. By default a minimum of three output   stations are specified (the two ends and the middle) for columns and   braces. 
  •   Min Number Stations     
       ETABS equally spaces the specified number of stations within   the clear length of the beam. Then a station is added for each point load that   does not lie at one of the previously defined output station locations. The   minimum allowed number of equally spaced stations is three. This provides a   station at each end of the beam and one at the center of the clear length. If   there are end offsets specified for the beam, the stations at the end of the   beam occur at the face of the end offset, not at the center of the   support.
  Note: ETABS determines the   location of output stations in a different order, depending on whether you   specify a minimum number of stations or a maximum spacing of stations.
  Note: The output station   spacing between one set of point loads may be different from that between   another set.